Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 45)

ASSEMBLY
Assembly Section 2-13
JOYSTICK CONTROL MOUNTING
The joystick control will require that the right armrest be modified and an additional
bracket attached that will accommodate the joystick. In doing this, the armrest must be
removed by sliding off the plastic cover and removing the capscrew from the lower right
side of the seat. After the capscrew is removed the armrest should be loose from the seat
and able to be removed at this point. Once the armrest is removed, then place the joystick
holder under the armrest, so that the indentation on the outside of the armrest is lined up
with the hole in the armrest bracket for the capscrew to pass through. Once the correct
placement is achieved, then mark on the armrest where the hole passes through the
armrest bracket. At this point a 1/2” hole must be drill through the armrest so that the
bracket can be secured to the armrest. After the hole is drilled, then on the inside of the
armrest the 1/2” hole must be cut to a larger diameter up to the metal plate in the armrest
so that a spacer and hex nut can be fastened to the capscrew that secures the armrest
bracket. Install the armrest bracket on the armrest with the hardware as shown in the parts
section. Once the bracket is installed on the armrest then reattach the armrest back onto
the seat using the existing hardware previously removed. Then install the joystick in the
bracket with the machine screws as shown in the parts section.
(ASM-JD-0082)
PRESSURE LINE INSTALLATION
(2004 UPDATE)
The hydraulic pressure line will be plumbed into the rear of the tractor remote valve end cap.
Locate the pressure port on the end cap and remove the plug (refer to the illustration below and
the Parts Section pages for position of the pressure port). After the plug is removed then install
22mm adapter. Next connect a 1/2” hose from the tractor remote valve to the Tiger valve.
(ASM-JD-0212)