Assembly, Deck attachment, Solenoid brake valve – Tiger BENGAL BRUTE JD 62-6420 User Manual
Page 55: Hose covering, Installing o-ring fittings
ASSEMBLY
Assembly Section 2-23
DECK ATTACHMENT
The pivot assembly is used to attach the head to the secondary boom. Install the deck pivot
cylinder using the pins and hardware, which is illustrated in the common section.
Connect the fittings and hoses from the pivot cylinder to the small preformed tubes on the
boom arm. Connect the fittings and hoses from the motor to the large preformed tubes on the
boom arm. Connect all remaining hoses from the control valve to the cylinders and / or
preformed tubes on the boom arm. Refer to common section for diagrams.
(ASM-C-0018)
SOLENOID BRAKE VALVE
Install a solenoid valve mounting bracket with the supplied hardware. While installing fittings
to the brake valve, the electrical coil on the spool must be removed to make room. When
reinstalling the coil, it is important to use no more than 5 ft. lbs. (or 60 in. lbs.) torque. Over
torque to the coil will result in hydraulic failure of spool.
(ASM-C-0017)
HOSE COVERING
Secure hoses together with zip ties wherever loose. Wrap the hoses with the hose covers as
illustrated in the parts book. Where hoses may contact the frame or other edges, wrap with split
hose and secure with hose clamps or zip ties. On non cab units the pressure and return hoses
from the control valve will also need to be routed inside the protective clear hose wrap.
(ASM-C-0019)
INSTALLING O-RING FITTINGS
Installing straight, 45º and 90º O-rings requires that the O-ring and washer be up against the
swivel body. Insert the swivel and turn in until the swivel is pointed in the desired direction and O-
ring contact is made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
(ASM-C-0056)