Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 37)

ASSEMBLY
Assembly Section 2-5
POLYCARBONATE SAFETY WINDOW
NOTE: Installing a boom mower requires that all of the right side windows be replaced, or
protected with a polycarbonate window. This should be done before mounting the main frame.
1. Disconnect gas shock at door. Remove the right side cab door/window glass from tractor cab
by removing hinge pins. Also, remove rear right side window.
2. Remove the existing hardware and discard factory glass door and window.
3. Place small bead of adhesive seal in the bottom of the trim lock bubble seal.
4. Install trim lock bubble seal on polycarbonate starting at the center bottom horizontal portion.
5. Install existing hardware removed from glass door and window on the polycarbonate.
6. Install the polycarbonate assembly in the cab with existing and supplied hardware.
7. Place the retaining brackets on the upper front and lower front (if applicable) of the cab door/
window with the 8mm capscrews.
8. Place the last bracket at the bottom of the door by the fender as shown in the illustration
below. Hold the bracket in place and mark the door jam.
9. Drill a 21/64” hole in the door jam for the 5/16” capscrew and moun the bracket.
10. Install the right rear poly window into place where the factory window was removed (if appli-
cable).
(ASM-JD-0052)