Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 40)

ASSEMBLY
Assembly Section 2-8
CABLE CONTROL LEVER STAND
On the corner cab post, mark a point at 1-3/8” from the windshield and 22-1/2” from the floor;
then cut a 3/4” diameter hole through the outer plastic shell. This will expose a threaded steel
boss to attach the control box support bracket.
The rear corner of the cable control stand is placed
approximately 6-1/4” from the edge of the mat. The front
edge of the stand is up against the corner cab post and the
door sill lip of the mat. Before you mark or drill any holes,
check for support plates or wires under the mat & the cab
floor. NOTE: Cutting into plates or wires makes more work
for everyone and could be dangerous. When you know
where the wires/plates lie, mark one of the mounting holes.
Drill a 3/8” hole through the mat and through the floor of
the cab. Next, lift the mat up and mark the other two holes
on the cab floor. Drill the holes through the floor. Mark the
mat and drill the other two 3/8” holes. Use a 1” hole saw
and cut a 1” hole through the mat over each 3/8” hole.
Secure the stand to the floor with the spacers, capscrews and nylock nuts provided.
Cut a 1-3/4” hole in the floor to route the cables and wires through. It needs to have a 1/4”
clearance for the trim lock. Before you mark or drill any holes, check for support plates or wires
under the cab floor.
NOTE: Cutting into plates or wires makes more work for
everyone and could be dangerous. Look under the floor
for cables and plates that you need to avoid. The hole
should be approximately 4-1/2” from the door sill and
4-3/4” from the lip of the mat under the console. Install the
trim lock around the metal edges of the hole, then route
the control cables and wires through the hole.
Next, wrap the cables with the 6” split hose at the point
they pass through the hole, and secure the zip-ties. Apply
RTV sealer in and around individual cables and split hose, inside and outside of the cab for a
water tight seal. Install upper support bracket from cab post to the control lever stand.
(ASM-JD CBL MNT-0002)