Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 71)

OPERATION
Boom Operation Section 3-9
©2011 Alamo Group Inc.
OPERA
TION
5.CONNECTING ATTACHING HEADS TO THE BOOM
1. Start by attaching the pivot bracket(3) to the boom(1)
using pin(5) and hardware. Next attach the cylinder to the
pivot bracket(3) using pin(8) and roll pins.
2. Then attach the dogleg(4) to the mower(2) using pin(7)
and hardware.
3. Use a hoist to lower the boom(1) down to the mower(2).
Insert the upper pin(6) through the end of the boom and the
mower. Attach with hardware.
4. Then align the dogleg(4) and the pivot bracket(3). Attach
with pin(9) and hardware.
5. Finally make sure all bolts, nuts, and pins are tightened to
recommended torque. OPS-B- 0004_D
Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and
hose connections. Relieve hydraulic pressure before performing maintenance or repairs.
Use gloves and eye protection when servicing hot components. Contact with a hot surface
or fluid can cause serious injury from burns or scalding.
(SG-34)
Do not operate this Equipment with hydraulic oil or fuel leaking. Oil
and fuel are explosive and their presence could present a hazard. Do
not check for leaks with your hand! High-pressure oil streams from
breaks in the line could penetrate the skin and cause tissue damage
including gangrene. To check for a hose leak, SHUT the unit ENGINE
OFF and remove all hydraulic pressure. Wear oil impenetrable gloves,
safety glasses and use Cardboard to check for evidence of oil leaks. If
you suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated immediately by a
physician knowledgeable and skilled in this procedure.
(SG-15)
6.PRE-OPERATION INSPECTION AND SERVICE
Before each use, a pre-operation inspection and service of the implement and tractor must be performed.
This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped
and functional, and performing needed repairs. DO NOT operate the unit if the pre-operation inspection
reveals any condition affecting safe operation. Perform repairs and replacement of damaged and missing
parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable down time
and repair cost can be avoided. OPS-U-0029