Texas Memory Systems RamSan-300/320 - Manual (Page 29)

4.2 Configuring Ethernet settings
The RamSan allows system monitoring and configuration through the
serial port and the Ethernet port. To access the system’s Ethernet port,
the administrator must assign the RamSan an IP address, subnet mask,
and possibly a gateway. The administrator may assign the IP address in
one of three ways: Static IP, DHCP, or No Ethernet. The default factory
setting is DHCP.
For any questions regarding IP assignment values, please consult your
network administrator.
4.2.1 Configuring Ethernet settings via Front Panel
To setup the Ethernet via the Front Panel, use the arrow buttons to
cycle through the top-level menu options until the display shows
“Ethernet Setup.” Use the Select button to choose this option
and continue with the configuration. You may now use the arrow
buttons to scroll through the following menu options:
• Displays a list of the
current IP
configuration,
hostname, IP
address, subnet
mask, gateway
address (if
applicable), and
hardware Ethernet
address.
• To continue setting
up the Ethernet
configuration
• Shuts down and
restarts the
Ethernet port using
the current IP
assignment
configuration
• Exits the setup
menu.
Show Current Config
Set IP Config
Restart Network
Exit Menu
Use the arrow buttons to scroll up and down through the list.
Pressing the “Menu” button returns to the previous menu, and
pressing the “Select” button exits the menu system. To continue
setting up the Ethernet configuration, select “Set IP Config.”
After selecting “Set IP Config,” you may use the arrow buttons to
cycle through:
RamSan-300/320 User’s Manual - 25 -