Texas Memory Systems RamSan-300/320 - Manual (Page 30)

• Enables you to set a
static IP address for
the RamSan.
• Sets the IP
configuration to
DHCP
• Disables Ethernet
• Returns to the Main
Menu without
making any
changes
Static
DHCP
None
No change
Talk to your network administrator for the proper IP assignment
type. The default factory setting is DHCP. Use the “Select” button
to select the desired method of IP assignment. If you did not
choose “Static IP” you are asked to confirm the selection with the
“↓” button.
To configure the RamSan with a static IP, the system requires the
IP address, subnet mask, and a possibly a gateway address.
After you have chosen
“Static IP,” “Ethernet IP”
replaces the top line of the
display, and the display
prompts you to enter an IP.
Use the “↑” or “↓” buttons
to cycle through the
numbers “0” through “9”.
To select the value, use the
“Select” button. Then, the
input prompt moves to the
next character position. To
back up a space, press the
“↑” and “↓” button
simultaneously. Repeat
this procedure until you
have entered the 4-byte
address. Press the “Menu”
button at any time to
cancel the Static IP
assignment.
Ethernet IP
_
RamSan-300/320 User’s Manual - 26 -