TOYOTA pmn - Manual (Page 27)

27
1.5. AIR HOSE AND CLAMP.
NOTICE:
– Follow the instructions below. Otherwise the hose may come off or intake air may leak, disabling
driving due to engine stop.
– Wrapping the hose clamp too tightly may damage the part or related parts.
1.6. OIL AND COOLANT.
Reuse the oil and coolant if it is judged possible from their condition.
Paint mark
3-5mm
3-5mm
Paint mark
Example:
(a) The paint mark on the air hose is the reference for positioning.
Align the mark with that of the pipe for fitting.
(b) When fitting the hose to the pipe, make sure to push in the hose
until it reaches the paint mark. If there is no paint mark on the
pipe, push the hose to the end.
(c) Unless otherwise specified in this manual, fit the hose clamp at
3 to 5 mm (0.118 to 0.197 In.) from the end of the hose.
HINT:
Do not wrap the hose clamp around the hose at a slant.
(d) When tightening the hose clamp, check the illustration in this
manual and make sure the position and orientation of the screw
is appropriate for on-vehicle maintenance.
HINT:
Tighten the hose clamp until the end of the clamp reaches
the paint mark, in order to ensure optimal tightening
condition.