TOYOTA pmn - Manual (Page 31)

31
3. HOLE PREPARATION.
(a) Drill the hole out to 11.2 mm.
(b) Remove burrs and protect the hole with anti-corrosion
primer.
(c) Insert the steel jack nut using the special tool.(SST
AM300-38300)
K: Jack nut tool (26-8)
K: Jack nut (20-3)
4. HARNESS FIXATION.
(a) Mount the harness clamp onto the vehicle harness.
K: Harness clamp. (20-1)
(b) Mount the clamp with 1 bolt and bracket into the jack
nut.
K: Bolt (20-2)
K: Bracket No. 1 (19-2)
Torque: 3 Nm
5. HARNESS GROMMET HOLE.(INTERIOR)
(a) Mark the position where to drill.
(b) Drill a 27 mm hole using a special hole-saw.
NOTICE: Ensure that all harness and vehicle
components in the interior AND engine
compartment are moved aside to avoid
damage during drilling.
(c) Remove burrs and protect the hole with anti-corrosion
primer.
Ø 11.2 mm
A
B
C
K
K
K
K
B
Ø 27 mm
A