Telit Wireless Solutions GE863 - Manual (Page 22)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
For example:
1 - Let's assume that the desired audio path is always the internal MT
Command:
AT#CAP=2<cr>
Answer:
OK
2 - Let's assume that the desired audio path has to be determined by HARDWARE pin AXE
Command:
AT#CAP=0<cr>
Answer:
OK
Now set the hardware pin AXE in the desired status.
2.6.1.3 Set the desired volume on the active audio path speaker output
This setting is not strictly necessary; it is also possible to keep the default volume setting.
• Send command
AT+CLVL=<vol><cr>
where:
<vol> is a number between 0 and 10 representing the volume setting:
0 – minimum volume
10 - maximum volume
• wait
for OK response
NOTE: The volume setting refers to the ACTIVE path ear line and is stored each time. When
changing audio path the volume setting will be reset to the previously stored value for that
audio path.
2.6.1.4 Check for microphone mute setting
The microphone of the active path can be muted with an AT command; to be sure that it is not muted,
it is suggested to check it with this command:
• Send command
AT+CMUT?<cr>
•
wait for response in the format:
+CMUT: <mute>
OK
where:
<mute> is the muting setting for the microphone:
0 - microphone active
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 22 of 109