Telit Wireless Solutions GE863 - Manual (Page 44)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
3.2.3.2 Restrict/Allow Caller line ID indication
• Send command
AT+CLIR=<n><cr>
where:
<n> is the operation mode selected:
0 – Calling Line Indication to the other party According to Network service status.
1 – Calling Line Indication Restriction Enabled (CLI not sent)
2 – Calling Line Indication Restriction Disabled (CLI sent)
• wait
for
OK
response
For example:
1- Let's assume you want to disable the CLI presentation to the other party permanently:
command:
AT+CLIR=1<cr>
response:
OK
3.2.4 Call Barring Control
The call Barring is a GSM service that allows the user to block certain types of calls:
•
•
•
•
•
•
•
•
Barring All Outgoing Calls
Barring Outgoing International Calls
Barring Outgoing International Calls except to Home Country
Barring All Incoming Calls
Barring Incoming Calls when Roaming outside the home country
All Barring services (applicable only for disabling command)
All Outgoing barring services (applicable only for disabling command)
All Incoming barring services (applicable only for disabling command)
The service can be queried, enabled and disabled.
NOTE: The call Barring service is handled by the network, hence all the relative commands
issue a network request and it may take several seconds to have the response from the
network.
Furthermore, all the Call Barring service commands must be issued when the mobile is
Registered on some Network, else an error code is returned ( no network service ).
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 44 of 109