Telit Wireless Solutions GE863 - Manual (Page 42)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
3.2.2.1 Set Caller line ID indication presentation
• Send command
AT+CLIP=<n><cr>
where:
<n> is the operation mode selected:
0 – Calling Line Indication Presentation Disabled
1 – Calling Line Indication Presentation Enabled
• wait
for
OK
response
For example:
1- Let's assume you receive a call from the national number 1234567890 and extended incoming calls
indication is disabled while CLIP is enabled, you'll see:
ring indication:
RING
+CLIP: "1234567890",129
2- Let's assume you receive a call from the international number +391234567890 and extended
incoming calls indication is disabled while CLIP is enabled, you'll see:
ring indication:
RING
+CLIP: "+391234567890",145
NOTE: this does not mean that the incoming call is an international one, it simply means that the
numbering scheme used to identify the caller is the international one.
3.2.3 Restricting Calling Line Indication
The GE863-GPS is able to send the calling line indication (CLI) to the other party through the network
when an outgoing call is made. This indication can be restricted (CLIR) in various ways:
•
•
•
•
CLI sent always
CLI never sent
CLI temporary sent (normally not sent)
CLI temporary not sent (normally sent)
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 42 of 109