TechniSat DIGIT MF4-S - Manual (Page 33)

on by means of the video recorder timer, this will be indicated
by the message “rEc” shown in the display.Most of the func-
tions of the remote control are disabled at this stage, to avoid
accidental interruption of the recording.
In stand-by mode, an active timer is indicated by the colon in
the time display blinking, or by the LED.
Deleting a SFI timer event
> If you would like to cancel a timer event programmed via the
SFI, proceed as described above, to mark the appropriate
programme.
> Press the red function key Timer to open a selection win-
dow.
> Use the arrow keys up/down to mark the line Delete
Timer.
> Confirm by pressing OK.
> To abort an active timer, switch of the digital receiver using
the On/Standby key.
> Press the same key again to switch the receiver on again,
and full functionality will be restored.
7.15.7.3 SFI programme overview
Use the SFI programme overview to display a table with the day’s
programmes of a single channel. To do this, proceed as follows:
> Press the SFI key.
The SFI table “Now” will be displayed.
> Press the blue function key SFI Menu to open a selection
window.
> Use the arrow keys up/down to mark the line
Programmes.
> Confirm by pressing OK. The day’s overview of the program-
me selected will be displayed. (Fig. 7-19)
> Use the arrow keys to move the marker to the desired pro-
gramme or time.
The individual days of the week will be shown along the
lower edge of the screen.
If information is available for the following days, the appropri-
ate fields will be marked.
> To display the programme contents for a specific day, use the
numeric keys to enter the number for the appropriate day.
33
(Fig. 7-19)