TechniSat DIGIT MF4-S - Manual (Page 47)

2. Satellite scan
Select this type of scan if you want to search for programmes only
on one speific satellite.
3. Transponder scan
Select this type of scan to search on only one specific transponder of
a satellite.
4. Manual scan
Use this type of scan to search specifically for a particular program-
me, using programme-specific PID numbers.
When the scan has been completed, a message will be displayed on
your TV screen, indicating the number of programmes your digital
receiver has found, how many of these are ne, and how many of
them are encrypted programmes. New programmes are stored in the
Total list,and can then be included in the Favourites list in accor-
dance with Point 8.1.
> In order to scan for programmes, first call up the Main
Menu. (Fig. 8-13)
> Use the arrow keys up/down to mark the line Scan.
> Confirm by pressing OK.
The sub-menu Scan will be displayed. (Fig. 8-14)
> Now use the arrow keys up/down to select the type of
scan you would like to perform, and confirm by pressing OK.
8.4.1 Automatic scan
When using this option, all the satellites set in the menu LNC
Settings (Point 6.4 and 9.4) will be scanned for programmes. You
can also decide whether you wish to scan for all programmes (free-
to-air and encrypted) or only for free-to-air programmes. (Fig. 8-15)
> Press the OK, key to decide whether you wish to scan only
for free-to-air programmes (Free) orwhether you wish to
include encrypted programmes (All).
> To confirm, press the red function key Start scan.
This scanning procedure may take more than 15 minutes.
Please also note any messages displayed on screen.
8.4.2 Satellite scan
To search a single satellite for programmes, select the option
Satellite scan. (Fig. 8-16)
You may decide to scan for all programmes (free-to-air and encryp-
ted) or only for free-to-air programmes.
> Press the OK key again to display the selection table sho-
wing all the active satellites.
47
(Fig. 8-16)
(Fig. 8-15)
(Fig. 8-13)
(Fig. 8-14)