Tiger Products Co., Ltd JOHN DEERE 5101E - Manual (Page 120)

MAINTENANCE
Side and Rear Flail Maintenance Section 4-32
©2012 Alamo Group Inc.
MAINTENANCE
DAILY MAINTENANCE SCHEDULE
The following services should be performed daily or every 8 hours of service, following the detailed
maintenance instructions in the operators manual.
_______ Pump Drive Shaft: Check for end play in driveshaft / coupler and lubricate at zerks.
_______ Crankshaft adapter: If equipped with rubber grommets check condition, replace if missing or
damaged.
_______ Pivot points: Inject grease until it appears at ends.
_______ Hydraulic fittings: Check for leaks with paper or cardboard. Tighten fittings or replace hoses
immediately.
_______ Knives: Inspect for missing or damaged knives, change (only complete sets) as needed.
_______ Belts: Check/Tighten/Replace belts as needed.
_______ Main Frame/Deck: Unless otherwise specified retorque bolts according to torque specifications in
this section.
_______ Hydraulic Fluid Level: Add, if required, per fluid recommendations.
_______ Rear Flail Drive, Bearing Flange and Shaft Couplers (if applicable): Grease as instructed in the
detailed maintenance section.
_______ Cutter Shaft and Ground Roller: Grease as instructed in the detailed maintenance section.
Service performed by:_____________________________ Date:____/____/____ Hour
Meter:_________________
Maintenance Section
**This page may be copied and used as part of the daily maintenance routine.