Tiger Products Co., Ltd JOHN DEERE 5101E - Manual (Page 37)

ASSEMBLY
Assembly Section 2-11
VALVE PLUMBING (WITH MID-MOUNT VALVE)
The tractor ports used are on the selective control valve (SCV) and the Mid-Mount
valve. The SCV is located between the right arm of the three point hitch and the axle.
The Mid-Mount valve is located under the right front corner of the cab. The power
beyond port is located on the bottom of the Mid-Mount valve towards the front. The
excessive flow port is located on the underside of the SCV. The return port is
accessed through the end of a run tee located on the SCV. See the lift valve page in
the parts section for hardware and location of parts.Refer to the image below as a
guide.
(ASM-JD-0067
Use the existing adapter in the power beyond port of the mid-mount valve for the
pressure hose. That hose is routed to the “P” port of the husco valve. The return
hose from the lift valve is connected to the closest end on the run tee of the “T” port on
the selective control valve. Plumb the power beyond hose from the “PB” port on the
husco valve to the “EF” port on the SCV. Refer to the Parts Section for hardware
used. The return line on the mid-mount valve must be replaced with a hose. This hose
is routed from the existing adapter in the return port on the mid-mount valve to the run
tee in the “T” port on the selective control valve.
SVC MID-MOUNT