Tiger Products Co., Ltd JOHN DEERE 5101E - Manual (Page 35)

ASSEMBLY
Assembly Section 2-9
VALVE MOUNTING
Attach the rear valve mounting bracket to the fender of the tractor by removing the
two rear bolts on the left fender and the two rear bolts on the right fender. See
illustration below. Drill the square holes in the fenders to accept 3/8” capscrews. Use
the hardware noted in the parts section to attach the valve mounting bracket to the
tractor.
Next, attach the valve mounting plate to the mounting bracket. Align the holes on
the plate to the holes on the bracket. Use the hardware shown in the parts section to
attach the plate to the valve mounting bracket. Finally, place the valve on the valve
mounting plate as shown in the parts section. Align the holes on the valve assembly
to the holes on the plate. Use the hardware provided to secure the valve to the plate.
Refer to the parts section for the placement of the valve and the hardware used.
Please handle the lift valve with care. It is extremely heavy and contains small
parts.
(ASM-JD-0065)