Thecus Technology i Series - Manual (Page 56)

3.8.3 Reset to default
Enter “Reset to default” function, it allows user to reset controller to the factory
default setting.
Figure 3.8.3.1
Reset to default sets password to default: admin, and set IP address to default
as Static IP.
Default IP address: 192.168.1.100 (Static IP)
Default subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
3.8.4 Config import & export
Enter “Config import & export” function, `it allows user to save system
configurable values: export function, and to apply all configuration: import
function. For the volume config setting, the values are available in export function
and not available in import function which can avoid confliction/date-deleting
between two controllers. That says if one controller already has valuable data on
the disks and user may forget it, use import function could return to the original
config. If the volume setting was also imported, the user’s current data will be
cleared.
Figure 3.8.4.1
1. Import: Import all system configurations including volume config.
2. Import Logical unit only: No system and volume configurations.
3. Export: Export all configurations to a file.
Caution
Import function will import all system configurations including
volume config, the user’s current data will be cleared.
- 56 -