TechniSat DigiCorder S1 - Manual (Page 12)

4.3.2 Via HF cable
If your television set is not equipped with a SCART socket,
the digital receiver will have to be connected to the antenna
input socket of the television set. If this connection is used,
only mono sound reproduction is possible.
To make the connection, proceed as follows:
e
Use a suitable TV connection cable to connect the
receiver (HF output) to the antenna input socket of
the television set.
f Connect the cable coming from the terrestrial antenna
to the Terrestrial antenna input of the digital receiver.
You must now set your television set to the transmission (out-
put) channel of the digital receiver. Select a free programme
slot on your television set, and tune it to Channel 38 (if
necessary, consult the operating manual of your television
set).
If you do not receive a clear picture on Channel 38, either this
channel or a neighbouring channel may already be tuned to a
programme being received via the antenna. You can check on
this by temporarily removing the antenna cable from the Input
terrestrial antenna socket of the digital receiver. If you then
temporarily receive a clear picture, you should select a diffe-
rent channel on the digital receiver, in the range 21 to 69.
Setting the UHF output channel
To set an optimum UHF output channel, please proceed as
described in 6.3, and go to the menu Audio/Video Settings
and mark the field UHF output channel. Then proceed as
described in 6.3.7.
4.4 Video cassette recorder (VCR)
g Connect the video recorder to the SCART socket
marked VCR. In Playback mode, the video recorder
will supply a switching signal to the digital receiver.
The video recorder signal will be sent automatically to
the TV set.
If your video recorder does not supply the required
switching current, use the 0/AV key to switch your digi-
tal receiver to the external input AV. Press this key
again to return to normal operation.
4.5 HiFi Amplifier
4.5.1 Analogue
To achieve the best possible sound quality, you may connect
the digital receiver to a HiFi amplifier. To do this, use a suita-
ble cable to connect the cinch sockets Audio R and Audio L
of the digital receiver with an input on your HiFi amplifier (e.g.
CD or AUX; please note that the Phono input is not suitable!).
12
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 12