TechniSat DigiCorder S1 - Manual (Page 37)

order to prevent an accidental premature interruption of the
recording. When the receiver is in standby mode, an active
timer will be indicated by a clock symbol shown on the
display.
3. Programme change timer
If your receiver is in normal operating mode, it will switch to
the pre-selected programme slot at the designated starting
time. In contrast to the hard drive or video recorder timers,
the full functionality of the unit is not restricted, and the unit
will not be switched off at the end of the programme.
Manual timer programming
> Press the Menu key to call up the Main Menu.
> Use the up/down arrow keys to mark the line Timer
organizing.
> Confirm by pressing OK.
The sub-menu Timer organizing will be displayed.
(Fig. 7-23)
> Use the up/down arrow keys to select the type of
timer you wish to programme.
> Press OK. A new window will be displayed, allowing
you to enter the programming data for a new timer
event. (Fig. 7-24)
To prgramme an event proceed as follows:
Source
>
Use the arrow keys to mark the column Source.
> Press OK.
> A selection window will be displayed. Use the
up/down arrow keys to select the desired source
(TV or Radio).
> Confirm by pressing OK.
Depending on the previous setting, either the TV or
the radio programme list will now be displayed.
> Use the arrow keys to mark the desired programme.
> Use the up/down arrow keys to move the marker
around the list one line at a time.
> Use the left/right arrow keys to move back-ward or
forward in the list one page at a time.
> Press OK to accept the selected programme into the
timer.
Date
>
Use the arrow keys to mark the column Date.
> Use the numeric keys to enter the date (4 digit form)
of the timer event.
Start
>
Use the arrow keys to mark the column Start.
> In this line, use the numeric keys to enter the starting
time for the timer.
37
(Fig. 7-23)
(Fig. 7-24)
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 37