TechniSat DigiCorder S1 - Manual (Page 23)

downloaded to the receiver. To do this, switch the unit
on and switch to reception of a major channel, such
as ZDF, that broadcasts a time signal, for about 30
seconds, to acquire the current time automatically.
7.2 Programme selection
7.2.1 Using the programme up/down keys
> Use the programme up/down keys either on the unit
or on the remote control to move up or down by one
programme slot at a time.
7.2.2 Using the numeric keys
> Use the numeric keys to enter the desired program-
me number.
For example:
1
for programme slot 1
1, then 4 for programme slot 14
2, then 3, then 4 for programme slot 234
When entering programme numbers of more than one digit,
you have approx. 3 seconds time after pressing a key to
complete the entry.
If you wish to enter a number consisting of only one or two
digits, you can speed up the switching procedure by holding
down the key a little longer on the last digit.
7.2.3 Using the Navigator (Programme list)
> Press OK.
The programme list navigator will be displayed. In TV
mode, only TV programmes will be shown, while only
radio programmes will be shown while in Radio mode.
The currently selected programme will be highlighted.
(Fig. 7-1)
> Now, use the up/down arrow keys to mark the selec-
ted programme.
> Press OK to switch reception to the desired program-
me.
> Use the up/down arrow keys to move around the list
one programme slot at a time.
> Use the left/right arrow keys to move around the list
one page at a time.
7.2.3.1 Selecting a list
To facilitate the finding of programmes, your receiver is
equipped with several programme lists. You have the choice
of selecting your Favourites list (see Point 8.1), or you can
use the alphabetically sorted Total list, or you can view a list
sorted by Providers.
23
(Fig. 7-1)
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 23