TechniSat DigiCorder S1 - Manual (Page 61)

9.3.2 Adjusting the satellite antenna
To adjust the antenna for the desired satellite, or to determine
whether the desired satellite can be received at the set
position, a test transponder has been programmed for each
satellite.
The indicators for signal strength and signal quality provided
by this test transponder facilitate the exact positioning of the
antenna.
9.3.2.1 Test transponder/LNC configuration
To change the data of the respective test transponder,
proceed as follows:
>
Use the arrow keys to mark the field Current
satellite list.
> Press OK to display the satellite list.
> Use the up/down arrow keys to mark the satellite
position for which you wish to change the data.
> Confirm by pressing OK.
> Now use the arrow keys to mark the field LNC config.
and press OK.
The menu LNC settings will be displayed. (Fig. 9-12)
> In this menu, enter the data relating to the test
transponder as well as for the LNC used, as described
in Point 6.4.3.
> Press Back to return to the menu for adjusting the
motorised antenna.
9.3.2.2 Manual adjustment of antenna
The optimum adjustment for the desired position can be
made with the help of the displays for signal strength and
signal quality. Adjust the antenna in such a way that both
bars indicated a maximum value.
>
Use the up/down arrow keys to mark the field Save.
> Now use the arrow key right (field East is marked)
resp. left (field West is marked) to turn the antenna to
the desired position. In each case, hold the key
pressed down until the desired position has been rea-
ched.
9.3.2.3 Automatic fine adjustment (Autofocus)
Before storing the satellite position in memory, you should
perform the automatic focussing function. This provides a fine
adjustment of the antenna to achieve optimum reception.
>
Press the yellow function key Actions to open a
window displaying the actions available.
> Now use the up/down arrow keys to mark the line
Autofocus.
> Confirm by pressing OK.
> Press the green key (Autofocus) to start the autof-
61
(Fig. 9-12)
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 61