TechniSat DigiCorder S1 - Manual (Page 76)

For everyday operation
Switching on and off
> Use the On/Standby key either on the unit or on the
remote control to switch on the digital receiver.
> Press the key again to switch the unit off.
> The unit is now in standby mode, and the current time
is shown on the display.
Programme selection
Using the programme up/down keys
> Use the programme up/down keys either on the unit or
on the remote control to move up or down the list by
one programme slot at a time.
Using the numeric keys
> Use the numeric keys to enter the required program-
me number.
For example
1
for programme slot 1
1, then 4 for programme slot 14
2, then 3, then 4 for programme slot 234
When entering programme numnbers with more than one
digit, you have approx. 3 seconds time after pressing a key to
complete the entry.
If you wish to enter a number with only one or two digits, you
can speed up the switching process by keeping your finger
pressed down a little longer on the last digit.
Using the programme list:
> Press OK.
> You can now use the up/down arrow keys to mark the
programme you wish to view.
> Press OK to select the marked programme.
> Use the up/down arrow keys to move up or down the
list one line at a time.
> Use the left/right arrow keys to move back or forward
in the list one page at a time.
Volume control
> You can adjust the volume of your digital receiver by
means of the keys Volume + for louder and Volume -
for softer volume.
> Press the key Sound on/off to switch the sound on or
off (mute function).
76
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 76