TMC ET4000 - Manual (Page 22)

12
Setting Up Your System
Setting Automatic Line Selection
To choose which line will be
automatically selected:
1 Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under NEXT
repeatedly, until ”Auto Seize”
appears in the display.
The display will show the current
auto seize setting.
3 Press the soft key under CHANGE
repeatedly, until the desired auto
seize setting is displayed.
The choices are:
Auto Seize:L1 (factory setting)
Auto Seize:L2
Auto Seize:L3
Auto Seize:L4
Auto Seize:INTCM
4 Press PROGRAM to exit.
This feature allows you to choose which line will
be selected automatically when you lift the hand-
set or press the SPEAKER button.
You may choose any of the outside lines or the
Intercom line. If your chosen line is in-use, the
telephone will automatically select the next avail-
able line.
Note: An incoming call that is ringing at your
telephone will be selected automatically when
you lift the handset or press the SPEAKER or
HEADSET button, regardless of the choices you
have made for automatic line selection.
If you wish to select a different line while your
phone is ringing, you must press the desired
LINE button before lifting the handset.
You may choose
any of the outside
lines or the Intercom
line to be selected
automatically when
you lift the handset
or press the SPEAK-
ER button
ET4000 UG for PDF v8 062502.qxd 6/25/02 12:51 PM Page 22