TMC ET4000 - Manual (Page 29)

To program:
1 Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under NEXT
repeatedly, until ”Line Connections”
appears in the display, and then
press ENTER.
The display will show the current
line connection setting for Line 2.
3 Press the soft key under CHANGE
repeatedly, until the desired line
connection setting for Line 2 is dis-
played.
The choices are:
L2: SHARED (factory setting)
L2: PRIVATE
L2: L2 AUX1
L2: UNCONNECTED
4 Press the soft key under NEXT to
see the current setting for Line 3,
and repeat steps 3 and 4 to change
the settings for Lines 3-4.
5 Press PROGRAM to exit.
Setting Up Private, Auxiliary and Unconnected Lines
While you must share the same Line 1 telephone
number at all the stations, you may choose to
leave some lines unconnected at particular sta-
tions or to connect private or auxiliary lines to
Lines 2, 3 or 4 at particular stations.
SHARED: This is the factory setting for all lines,
and is the setting you use if the particular line is
connected at this station to the same telephone
number as the corresponding line at the other
stations.
PRIVATE: Use this setting at any telephone that
is connected to a different telephone number
than the corresponding line at the other stations.
For example, you may connect your private tele-
phone number to Line 3 at your station instead of
connecting your station to the shared Line 3. In
this example, you would set Line 3 at your sta-
tion as PRIVATE.
AUX: Use this setting if two or more stations are
connected to a different telephone number than
the corresponding line at the other stations, but
they share the same number among them-
selves. For example, you may connect a group
of stations to a separate Line 3 telephone num-
ber than the rest of the system, yet they share
that same Line 3 telephone number among
themselves. In this example, you would set Line
3 at these stations to “L3 AUX1.”
Note that you can have up to one auxiliary Line
2, one auxiliary Line 3, and up to two auxiliary
Line 4’s.
UNCONNECTED: Use this feature at any tele-
phone that is not physically connected to all of its
lines. For example, you may install an EPIC 4-
line telephone in a room that is currently wired
for only lines 1, 2 and 3. In this example, you
would set Line 4 at this station as UNCON-
NECTED.
Setting Up Your System
ET4000 UG for PDF v8 062502.qxd 6/25/02 12:51 PM Page 29