TMC ET4000 - Manual (Page 73)

Centrex Operation
Setting a Telephone to Ring a Centrex Console
63
To set up a telephone to ring a
Centrex console:
1 Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under NEXT
repeatedly, until “Ring Console”
appears in the display, and then
press ENTER.
The display will show the current
ring console setting.
3 Press the softkey under CHANGE
until the desired ring console setting
is displayed.
The choices are:
Ring Console: NO (factory setting)
Ring Console: YES
4 If you have chosen “YES,” then you
must decide how many seconds you
want this station to delay before
ringing the Centrex console. Press
CHANGE repeatedly to choose a
delay of between 2 and 30 seconds.
Note that one ring cycle is approxi-
mately 6 seconds.
Then you must press the soft key
under CHANGE until the desired
Centrex Line is displayed.
The choices are:
Centrex Line: L2
Centrex Line: L3
Centrex Line: L4 (factory setting)
5 Press PROGRAM to exit.
If you wish your telephone to notify any Centrex
consoles that may have been set up that your
Centrex line is ringing, you must choose how
long you want your phone to delay before alert-
ing the Centrex console.
Note that if you wish your telephone to alert a
Centrex Console, you must set your ring con-
sole setting to “YES.”
Then you must decide how many seconds you
want your station to delay before alerting the
Centrex Console. You may choose a delay
between 2 and 30 seconds.
In addition, you must specify which one of your
lines is your private Centrex line. This is impor-
tant, because only when this line rings will the
Centrex console be alerted. Calls ringing on the
other lines will have no effect on the console.
Note that once you set up your telephone to
ring a Centrex console, you are simply broad-
casting an alert whenever your Centrex line is
ringing. The alerts that you broadcast will be
received by any other station that has been set
up as a Centrex console for your station.
ET4000 UG for PDF v8 062502.qxd 6/25/02 12:52 PM Page 73