Toshiba T300MVi - Manual (Page 18)

5
3. Installation
Before opening the drive, please observe all safety precautions as outlined on
the unit's front cover and in the operation manual. Installation of the interface
should only be performed by a qualified technician familiar with the
maintenance and operation of the drive.
1.
CAUTION!
Verify that all input power sources to the drive
have been turned OFF and are locked and tagged out.
2.
DANGER!
Wait at least 5 minutes for the drive’s
electrolytic capacitors to discharge before proceeding to the next step. Do
not touch any internal parts with power applied to the drive, or for at
least 5 minutes after power to the drive has been removed. A hazard
exists temporarily for electrical shock even if the source power has
been removed.
3. Open the drive’s cabinet door (refer to the drive manual for instructions
how to do this).
4. Press the interface board firmly onto the connectors marked CN4 and CN5
on the drive’s control board.
5. Connect the various network cables to their respective plugs/terminal
blocks. Ensure that any terminal blocks are fully seated into their
respective headers, and route the network cables such that they are
located well away from any electrical noise sources, such as ASD input
power or motor wiring. Also take care to route all cables away from any
sharp edges or positions where they may be pinched.
6. Take a moment to verify that the interface board is seated properly, and
that all network cables have sufficient clearance from electrical noise
sources.
7. Close the drive’s cabinet door.
8. Turn the power source to the drive ON, and verify that the drive functions
properly. If the drive does not appear to power up, or does not function
properly, immediately turn power OFF. Repeat steps 1 and 2 to remove
all power from the drive. Then, verify all connections. Contact Toshiba
for assistance if the problem persists.