Toshiba T300MVi - Manual (Page 39)

26
Figure 13: HyperTerminal receive file dialog box
When uploading a file, the procedure is similar to downloading. Enter “/u”
instead of “/d” for the action parameter of the xmodem command. Once the
xmodem upload command is entered, the user will have 30 seconds to click the
“send” button (
) on the tool bar in HyperTerminal and initiate the Xmodem
upload transaction. Upon successful completion of the Xmodem upload, the
unit will reset, and the uploaded file will become the unit’s active configuration.
The previous configuration cannot be recovered (unless a corresponding
configuration file exists, of course). Note that uploading a file will also cause
the unit to become “configured” (refer to section 14.2).
Ping config reset: This command re-enables the ability to configure the unit’s
IP address via the ARP method (refer to section 12.1). For security reasons,
whenever the ARP method of configuration is successfully completed, the unit
disables this method, and subsequent attempts at ARP configuration will be
ignored. By entering the “ping config reset” console command, however, the
unit will once again allow the ARP method of configuration. Refer to Figure 14.
Recall that the current ARP method configuration status can always be
obtained via the “show” command.
Figure 14: "Ping Config Reset" Overview and Implementation