Toshiba T300MVi - Manual (Page 50)

37
14.10 Upload Port and Point Configuration
Once all desired changes have been made to the port and point configurations,
this data must be uploaded to the interface. This is performed by clicking the
“SUBMIT” button shown in Figure 25.
Figure 25: Port and Point Configuration Upload
Submitting the port and point configuration may require up to 1 minute to
complete, during which time a “please wait” graphic will be displayed. Once the
upload completes, the interface will return to its normal screen. However,
clicking your browser’s refresh button may be required to reestablish
communications with the interface.
This process will also result in the loss of communications with all devices
connected to the interface. It is important to ensure that all connected devices
are in a safe state such that loss of communications will not pose a danger to
equipment or personnel before using this feature.
14.11 Radix Selection
Figure 26 shows the radix selection buttons. These selection buttons allow
changing the point value data display and entry radix between decimal and
hexadecimal formats.
Figure 26: Radix Selection
14.12 Editing Point Values
The value of the currently selected point can be modified using the interface
shown in Figure 27. The radix of the value entered here is determined by the
radix selection described in section 14.11. Editing the point value in this
interface and selecting “SUBMIT” immediately updates the point’s value in the
unit, which will result in a write to the point’s configured “Source Port” if one is
assigned.