Texas Instruments 3000 WinSX - Manual (Page 81)

System Options, Page 1
When you start (boot or reboot) the TravelMate 3000 WinSX, the Setup Program checks
the total memory available. If your settings exceed total available memory, the computer
displays an error message the next time it boots, asking you to run the 'SET_UP" program.
Press the Enter key, follow the prompts, and check your memory settings.
Diskette Drives
The Diskette category enables you to select the type of floppy in use. The settings
available are 5.25" 360 KB, 5.25" 1.2 MB, 3.5" 720 KB, and 3.5" 1.44 MB, or Not
Installed.
Diskette A
This item specifies the standard floppy drive (drive A) installed in your computer. Set
Diskette A to 3.5" 1.44 MB (the factory default) unless you are using an external drive you
want to address as drive A that requires a different setting.
Diskette B
Set this item to Not Installed unless you have an external floppy drive connected to your
computer. Then set this item to match the external drive, and address the external drive
as drive B. The default is Not Installed.
Hard Disk Drives
The Hard Disk category specifies the built-in hard disk drive and a future external hard
disk option.
Hard Disk 1
The Hard Disk 1 category is the standard built-in 60 MB hard disk drive. The system sets
this category automatically; you should never have to reset it from Type 34 unless you
replace the standard disk drive.
4- 1 0 Customizing Your Computer