TurboChef Technologies TurboChef - Manual (Page 28)

Loading a Menu from a Smart Card
1. Ensure the oven is in the
OVEN OFF
/
COOLING
DOWN
mode.
2. Enable the
LOAD MENU
function (page 19). The
oven will return to the Off screen.
3. Remove the lower access panel (Figure 14).
4. Insert smart card into oven (Figure 14).
5. Press the bottom-left soft key.
6. Select
LOAD MENU FROM CARD
. The menu on
the smart card will load to the oven.
7. When this process completes, the oven will
beep. Remove the smart card and reattach the
lower access panel.
8. If the oven is a Subway oven, disable the
LOAD
MENU
function (page 19). For all other ovens,
leave it enabled.
OVEN OPTIONS
Done Screen
To enable/disable the Done Screen (Figure 15), see
the next page. Enable the Done Screen to:
†
Cook an item longer after the end of a cook cycle.
†
Save an adjusted cook time (only if Time Screen is
also enabled).
Time Screen
To enable/disable the Time Screen (Figure 16), see
the next page. Enable the Time Screen to:
†
Adjust the cook time before initiating a cook cycle.
†
Save an adjusted cook time.
Snooze Mode
To enable/disable the Snooze Screen, see the next
page. Enabling the Snooze Screen will allow the oper-
ator to set the oven in a mode during which all oven
operations are turned off, but the heaters remain on.
The cook cavity will remain at the set temperature,
and the IR temperature will drop 200ºF (104ºC)
below the IRSI. This allows fast recovery when the
oven is again turned on.
DONE
SAVE
TIME
COOK
MORE
ENTER COOK TIME
00:20
START
F I G U R E 15: Done Screen F I G U R E 16: Time (Start) Screen
THE CONTROL SYSTEM 18
F I G U R E 14: Inserting Smart Card