TurboChef Technologies TurboChef - Manual (Page 48)

The proper fit and adjustment of the oven door is
essential for safe and reliable operation of the NGC
(Tornado) oven.
The oven door provides three primary functions:
1. To protect the operator from the hot
convection airflow.
2. To protect the operator from exposure to
microwave energy.
3. To actuate the interlock switches.
REMOVING/REINSTALLING THE OVEN DOOR
To remove or reinstall the oven door, follow the
steps below. Refer to Figure 26.
1. Ensure the oven has cooled.
2. Open the oven door to its full open position.
Locate the two (2) thru holes in the bottom of
the left and right hinge assemblies. Insert a screw
or nail into the holes to keep the hinges open
while removing the oven door.
3. Locate and remove the #38 screws (3 each side).
4. Remove the plastic caps.
NOTE
: The 10x32 screws do not need to be
removed, as they are used for adjusting the door.
5. Remove the oven door by pulling the door away
from the oven. It will slide off the hinges.
OVEN DOOR PARTS
Figure 26
38. 102809 #8-32 x 3/8” PFH CSK
39. NGC-3067 Assy, Oven Door (Traditional)
NGC-3067-2 Assy, Oven Door (SBK)
40. NGC-1061 Hinge Block
41. 102804 Right Hinge
42. 102805 Left Hinge
43. 101381 #10-32 x 1/2” Hex SS
44. 102140 #10 Flat
45. 102350 #10 Split Lock
46. 101191 Cap, Hole
F I G U R E 26: Oven Door Removal & Parts
38
39
40
41
2
42
43 44
45 46
THE OVEN DOOR 37