Tyan Computer Transport GX21 B2735 - Manual (Page 23)

2.1 Before you begin
Chapter 2: Setting up 15
Chapter 2: Setting up
2.1 Before you begin
This chapter explains how to install motherboard components
including CPUs, memory modules, and PCI card. There are
also instructions in this section for installing S-ATA, SCSI and
IDE hard drives.
Careful attention should be given to the precautions men-
tioned in this section when setting up your system.
2.1.1 Work area
Make sure you have a stable, clean working environment.
Dust and dirt can get into components and cause malfunc-
tions. Use containers to keep small components separated.
Putting all small components in separate containers prevents
them from becoming lost. Adequate lighting and proper tools
can prevent you from accidentally damaging the internal
components.
2.1.2 Tools
The following tools will be required to complete the installa-
tions described in this chapter.
• A cross head (Phillips) screwdriver
• A grounding strap and/or anti static pad
Most of the electrical and mechanical connectors in your sys-
tem can be disconnected using your fingers. It is recom-
mended that you do not use needle-nosed pliers to remove
connectors as these can damage the soft metal or plastic
parts of the connectors.