Tyan Computer Transport GX21 B2735 - Manual (Page 55)

3.4 Replacing the floppy disk drive
Chapter 3: Replacing pre-installed components 47
3.4 Replacing the floppy disk drive
This chapter describes how to replace the floppy disk drive.
3.4.1 Replacing the floppy disk drive (B2735G21S2)
Follow these instructions to replace the FDD in your
B2735G21S2 system.
1. Remove the chassis cover as described in section 2.2.1
Removing the chassis cover.
2. Locate the drive bay housing the slim CD-ROM drive and
the FDD and remove power and data cables from both.
Note:
Unless you are intending to replace
the CD-ROM drive, there is no need to
remove the CD-ROM backplane.
3. Remove the 4 screws that secure the drive bay to the
chassis and lift the drive bay free.
4. Remove the four screws that secure the FDD in the drive
bay and slide the unit out of the drive bay.
Note:
The FDD bay can be used to house
an additional IDE HDD if required.