Tyan Computer Barebone System B4881V50S4H - Manual (Page 28)

2.3 Installing hard drives
20 Chapter 2: Setting up
2.2.5 Installing PCI-X cards
Follow the instructions in this section to install a PCI card in
your system.
1. Remove the chassis cover. See Removing the chassis
cover on page 13.
2. Remove a blanking plate from the rear panel of the chas-
sis as shown.
3. Insert the PCI/PCI-X card into a spare slot as shown.
4. Secure the PCI card with the screw you removed with the
blanking plate.
2.3 Installing hard drives
The B4881V50S4H supports eight, hot-swappable SCSI or
SATA hard drives. The unit is shipped with four hot-swap
bays and a SATA back plane. A further four hot-swap bays
can be added with either a SATA or SCSI backplane.
Screws Required Location
1 hex head #6-32-L6 PCI card