Tyan Computer Barebone System B4881V50S4H - Manual (Page 50)

3.5 Replacing the SATA backplane
42 Chapter 3: Replacing pre-installed components
2. Remove all the SATA hot-swap HDD trays from the
B4881V50S4H.
3. Remove all cables from the SATA backplane.
4. Remove the two screws holding the cradle locking bar in
place and remove the bar.
5. Lift the disk drive cradle to the vertical position as shown.
Remove the six screws and lift the backplane from the
chassis.
6. Place a new backplane in position and secure in place
with six screws.
7. Lower the disk drive cradle into place.
8. Replace the power and data cables.