Tyan Computer Barebone System B4881V50S4H - Manual (Page 32)

2.3 Installing hard drives
24 Chapter 2: Setting up
Note:
The product is shipped with a SATA back-
plane. To install hot-swap SCSI drives, the
optional SCSI backplane must be fitted.
5. Insert the drive tray back into the chassis and push the
locking lever into place to secure it.
2.3.3 Installing internal hard drives
The B4881V50S4H ships with four drive bays that can each
accommodate a standard SCSI, SATA, or IDE hard disk.
1. Attach a rail to each side of new hard disk. Ensure that
the locking clip faces the rear of the drive. Use two
screws for each rail.
2. Remove the chassis cover. See Removing the chassis
cover on page 13.