Tyan Computer Barebone System B4881V50S4H - Manual (Page 48)

3.4 Replacing the floppy disk drive
40 Chapter 3: Replacing pre-installed components
6. Secure the backplane to the new CD-ROM drive with two
screws.
7. Slide a new CD-ROM unit into the cradle and secure it
with four screws.
8. Slide the cradle with the new CD-ROM unit back into
place in the chassis. The release catch will click and
secure the cradle in place.
9. Replace the data and power cables.
3.4 Replacing the floppy disk drive
This section describes how to replace the SCSI backplane on
your B4881V50S4H.
1. Loosen the two screws that secure the lower cover to the
chassis of the B4881V50S4H. Slide the cover back and
remove it to expose the service port for the floppy disk
drive.