TANDBERG S3.1 - Manual (Page 24)

24
D13898.06
MAY 2008
TANDBERG CONTENT SERVER
ADMINISTRATOR GUIDE
Table of
Contents
Introduction Installation Quick Setup
TCS
Administration
Backing up and
Restoring
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
Shutting Down and Restarting
Restarting the Content Server System Status
Press 1. Enter to display the Main Menu
screen
From the
2. Main Menu screen, use the
Up or Down arrow to select Commands
Press 3. Enter to confirm your selection
From the 4. Commands menu, use the Up
or Down arrow to select Restart and
press Enter
You will be asked to confirm this 5.
action on the following screen. At the
Restart? prompt, use the
Up or Down
arrow to select Yes and press Enter to
confirm.
The LCD panel display indicates the current status of the
Content Server.
In addition you will also find the currently installed version, as
can be seen from the below menu structure.
Shutting Down the Content Server
Press 1. Enter to display the Main Menu
screen
From the
2. Main Menu screen, use the
Up or Down arrow to select Commands
Press Enter to confirm your selection 3.
From the 4. Commands menu, use the Up
or Down arrow to select Shutdown and
press Enter
You will be asked to confirm this 5.
action on the following screen. At the
Shutdown? prompt, use the
Up or
Down arrow to select Yes and press
Enter to confirm.
IMPORTANT 6. —wait until is is safe to shut
down the Content Server and the LCD
panel displays Power off.
LCD panel display when a call is
currently in progress.
LCD panel display when no calls are
currently in progress.
LCD panel display when transcoding
is in progress.
Command Menu Structure
Restoring Default Settings
is described on the next
page.
IP Settings. See the Installation section.
Display information on the
version currently installed.
Do not Shutdown or Restart the Content Server
While Calls Are In Progress!
!
We do not recommend to shutdown or restart the
Content Server while calls are in progress. If the Content
Server is in a call and the server is restarted or shut
down, calls in progress will fail and will not be recorded.
For details on how to restart the Content Engine service
without restarting the Content Server, see the
Administrator Settings section.
IP Settings
Commands
Version Info
Restart?
No
Yes
Shutdown?
No
Yes
- Restore Defaults -
Full Restore
Config Restore
Full Restore?
No
Yes
Config Restore?
No
Yes