TANDBERG S3.1 - Manual (Page 39)

39
D13898.06
MAY 2008
TANDBERG CONTENT SERVER
ADMINISTRATOR GUIDE
Table of
Contents
Introduction Installation Quick Setup
TCS
Administration
Backing up and
Restoring
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
Site Settings
E.164 Gateway Prefix . Alias prefix if registered
as a gateway.
Current Status. Displays the status of Content
Server registration with the gatekeeper (registered
or not registered).
Gatekeeper Enabled. Choose Enabled to
register with the gatekeeper.
Gatekeeper Discovery Gatekeeper discovery is
always set to manual on the Content Server.
Manual gatekeeper discovery means that you will
register with one specific gatekeeper, identified
by its IP Address.
Gatekeeper Address . This gatekeeper IP-address
will be used to register the Content Server.
Registration . Choose to register the Content Server
as a Terminal or as a Gateway .
H.323 Gateway Prefix . Alias prefix if registered
as a gateway.
Restart Service (see Site Settings ) will
terminate calls that are currently live (that is,
the calls will be ended and conferences will
not be available for on demand playback).
Before restarting the service, check if there
are live conferences in progress in the
Live
Conferences page or check the call status on
the LCD panel of the unit. The Site Settings
page will also display a warning if calls are in
progress. If you click on the
Restart Service
button while calls are in progress, you will be
asked to confirm if you want to go ahead with
the restart.
E.164 Alias. Other systems can call the
Content Server using the E.164 Alias, if the
Content Server is registered to the gatekeeper.
The recording alias specified in the
Default
Recording Aliases will be used for the call.
H.323 ID. Other systems can call the Content
Server using the H.323 ID, if the Content
Server is registered to the gatekeeper. The
recording alias specified in the
Default
Recording Aliases will be used for the call.
Gatekeeper Settings
Authentication. By default, authentication
is set to Off. If the gatekeeper requires that
systems must authenticate with it before
they are allowed to register, then change
to Auto and supply the User name and
Password that will be used by the Content
Server.
User name. Enter the user name to
authenticate toward the gatekeeper.
Password. Enter the password to
authenticate toward the gatekeeper.
Password confirm. Re-enter the password.