TANDBERG D13187-03 - Manual (Page 19)

TANDBERG Gateway
19
Using the Gateway
Actions
When a call is active, the Administrator or Operator has the possibility to disconnect the call, or transfer the call
from one IP endpoint to another.
Disconnect Gateway Call
Will disconnect the selected gateway call. A confirmation window will be shown.
Call Transfer
Will open the H.323 Call Transfer window. Here the Administrator or Operator can select an IP entry from
the Phone Book or enter a H.323 Alias/IP address and transfer the H.323 (IP) call to another IP endpoint.
If the transfer fails, the call will be disconnected.
Status
Shows current status on the PRI and IP status.
PRI:
Minimum one PRI line is synced and active. Click on More... to see status in detail.
No PRI lines are active. Click on More... to see status in detail.
IP/H.323:
The gateway is registered with a Gatekeeper. Click on More... to see status in detail.
The gateway is not registered with a Gatekeeper. Click on More... to see status in detail.
If encryption mode is set to “Independent”, then a warning is shown in the Status area.