TANDBERG D13187-03 - Manual (Page 46)

46
TANDBERG Gateway Configure the Gateway
SNMP Configuration
SNMP (Simple Network Management Protocol) is used for monitoring and configuring different units in a network.
The gateway’s SNMP Agent responds to requests from SNMP Managers (a PC program etc.). SNMP traps are
generated by the agent to inform the manager about important events.
Configuration
SNMP Community Name
SNMP Community names are used to authenticate SNMP requests. SNMP requests must have this ‘password’
in order to receive a response from the SNMP agent in the gateway.
SNMP Trap Host (1, 2 and 3)
Identifies the IP-address of the SNMP manager. Up to three different SNMP Trap Hosts can be defined. Your LAN
administrator should provide the correct values for these fields.
System Contact
Used to identify the system contact via SNMP tools such as HPOpenView or TANDBERG Management Suite.
Location
Used to identify system location via SNMP tools such as HPOpenView or TANDBERG Management Suite.
Save
Press ‘Save’ to activate the new settings.
T HE SNMP C OMMUNITY NAME
IS CASE SENSITIVE .
NOTE