Tyco Electronics MM102014V1 - Manual (Page 18)

MM102014V1, Rev. G
Icons
Network
Connectivity
(OTP Mode)
Volume Level
Two Text Lines
Figure 4-2: Sample Display (Talk Group Menu Session)
4.2.1 Network Connectivity Icon (OTP Mode Only)
The illuminated network connectivity icon (refer to Table 4-2) indicates network connectivity has been
achieved. This icon will always be illuminated when the powered radio is connected to the “network.”
Transmitting voice communications may be possible even if the Network Connectivity
icon is not illuminated. However, reception of voice calls from others is not guaranteed
while in this state.
4.2.2 Volume Level Icon
As shown in Figure 4-2, the volume level icon indicates the current speaker/headset volume setting. Turn
the volume dial to change the setting.
In addition to the volume level icon at the right of the display, volume level is also
presented numerically within the display. This numeric representation only appears
during, and briefly after, the volume adjustment is made.
4.2.3 Display’s Top Line
The display’s top line of text changes as the  and  menu buttons are pressed to scroll through the
selections in the active menu. When the dwell display is present, press the  and  buttons to scroll
through available talk groups. The top line of the display also indicates other information such as the
selected talk group when the dwell display is active, and alert messages.
4.2.4 Display’s Bottom Line
The display’s bottom line of text changes as the c and d menu buttons are pressed to scroll through the
menus. The menu structure is shown in Table 4-3. The bottom line of the display also indicates other
information such a login prompt, emergency status, and dwell display messages as described in the
following section.
18