Tyco Electronics MM102014V1 - Manual (Page 37)

MM102014V1, Rev. G
5.13.2 Changing Priority Talk Group
The following lists the scanning priority order (from highest to lowest):
• Selected talk group in emergency state
• Default emergency group in emergency state
• Selected talk group
• Emergency capable group in emergency state
• Priority 1 talk group
• Priority 2 talk group
• Other (non-priority)
To Set Scan Priority:
1. Use the ▲ or ▼ button to scroll through the menu until “Priority1” or “Priority2” appears in the
display (Priority1 group has higher priority than the Priorty2 group).
2. Use the ◄ or ► button until the desired talk group is displayed.
3. Press the Select button to set the newly selected talk group as the Priority 1 or Priority 2 talk group.
• Changing the priority of a listen group does not change your talk group.
• You can set priority for two talk groups, but only in the selected profile.
• The scanning priority settings are reset to the default values when the radio is turned
off.
5.14 SELECTIVE CALL
Selective calling is a feature that allows two radio units to obtain and utilize an independent voice path for
a private call. Radios can be configured to both initiate and receive selective calls or to only receive
selective calls.
In the OpenSky system, a source radio can be configured to initiate selective calls through a pre-
programmed list in memory. This method uses the “speed dial list” set up by the OpenSky network
administrator and provisioned as part of the registration process.
In addition, a properly equipped source radio can initiate a selective call to any radio in the system by
entering the ten-digit voice user ID (which looks like a telephone number) of the target device. Entering a
selective call number without using the speed dial feature requires an optional DTMF microphone. See
Section 5.18 for more detail.
Selective calls are terminated if an emergency is declared.
37