Tyco Electronics MM102014V1 - Manual (Page 26)

MM102014V1, Rev. G
5 BASIC OPERATION IN OTP MODE
5.1 TURNING THE RADIO ON
1. If set-up to turn the radio on and off, press the Power Button/Volume Dial as indicated in Figure
5-1. The display will illuminate when the radio powers up. However, the Power Button control can
be configured in another way as described in the following NOTE.
Figure 5-1: Power Button/Volume Dial
2. Wait for the power-up sequence to complete, which takes approximately ten (10) seconds.
During this time, if enabled for auto registration, the radio is provisioned with a customized user
personality designed for the user’s specific needs by the OpenSky network administrator.
If this personality contains encrypted talk groups or the user is authorized for, and intends to use,
manual encryption, User Login must be performed. This requires a microphone with a DTMF keypad
so that the User ID and password can be entered.
3. When provisioning is complete, the radio will display the Dwell Display. See Figure 5-2.
If User Login is required, the bottom line of the Dwell Display will flash the message “Pls Login.”
Figure 5-2: Dwell Display and Speaker Volume Icon
26