Tyco Electronics MM102014V1 - Manual (Page 46)

MM102014V1, Rev. G
If the password is wrong, the radio will not successfully register with the network for wide
area voice reception. The radio can still be used in single-site mode.
5.18.2 DTMF Overdial
Using the DTMF microphone, the radio can transmit DTMF tones corresponding to numbers/characters
0-9, * and # on the mic’s keypad. To overdial numbers/characters, transmit by pressing and holding the
PTT button and then, press the corresponding keys (one at a time) on the keypad.
5.19 ENCRYPTION
In the OpenSky network, both data and voice use a 128-bit key encryption standard published by the
Federal Information Processing Service (FIPS), called Advanced Encryption Standard (AES). AES is
approved by the U.S. Department of Commerce for encryption of classified materials.
When encryption is enabled on the network, data is encrypted from the Mobile Data Intermediate System
(MDIS) to the Mobile End System (MES) (e.g., M-803 mobile radio). This form of encryption provides
air-link security.
Voice encryption is handled either automatically or manually. Automatic encryption is initiated through
the Unified Administration System (UAS), formerly known as the NAS, for a specific talk group and
requires nothing from the user. Manual encryption is initiated by two or more radio users and requires
DTMF microphones. Both methods of encryption are discussed in the following sections.
5.19.1 Automatic Encryption
For automatic encryption, a network administrator will select the talk group to be encrypted at the
interface to the UAS. Once the talk groups have been selected and identified as secure, credentials for key
generation are generated automatically by the system and provisioned to authorized users. This process
requires that authorized users login to the network and be authenticated. Encryption keys require no
manual handling and are never sent “in the clear” over any network interface or air-link.
1. “Pls Login” appears displayed in the bottom line of the dwell display.
2. Login normally using the DTMF microphone to enter User ID and Password.
If a user is engaged in a call on a talk group encrypted at the network administrator level, “Secure Call”
will appear in the bottom line of the dwell display if the user is logged in to that talk group.
If a secure call is in progress elsewhere and the user has not logged in, the bottom of the dwell display
will alternate between “No Access” and the alias of the radio that is currently engaged in the secure call.
5.19.2 Manual Encryption
Two or more users can manually encrypt a call, if enabled, without an established encrypted talk group. A
pre-determined key and a DTMF microphone are required at each radio.
46