Trimble Outdoors SPSX51 - Manual (Page 101)

C H A P T E R
8
SPSx51 Modular GPS Receivers User Guide 99
Automatically Setting up a Mobile Base
Station Using AutoBase Technology
8
In this chapter:
Q AutoBase Warning
Q Working with AutoBase
technology
Q Scenario One: First visit to a
site with AutoBase
Warning turned off
Q Scenario Two: First visit to a
site with AutoBase
Warning turned on
Q Scenario Three: Repeat visit
to a site with AutoBase
Warning turned off
Q Scenario Four: Repeat visit
to a site with AutoBase
Warning turned on
Q The AutoBase process
The AutoBase technology is a feature of the
Trimble receivers that enables you to reduce
daily setup time for mobile base stations and to
reduce the likelihood of using incorrect base
station coordinates during setup.
The AutoBase feature allows you to set up a
receiver as a base station receiver and save you
time so you do not need to reconfigure the
receiver at the start of each day. It also allows you
to set up the base station on a new site without
needing to configure the settings in the receiver.
Even if you have used the AutoBase
feature in other Trimble receivers, Trimble
recommends that you read this chapter carefully
because new functions in this feature provide
greater benefit to you.
Note – For information about turning AutoBase off
using the receiver, see Chapter 6, Configuring the
Receiver Using the Keypad and Display .