Trimble Outdoors SPSX51 - Manual (Page 72)

6 Configuring the Receiver Using the Keypad and Display
70 SPSx51 Modular GPS Receivers User Guide
Managing application files
You can use the front panel to manage application files in the receiver. You can see
which application file the receiver is currently using and then choose to make changes
to it and save it, load a different application file, or delete an application file.
To manage the application files, use the System Setup menu (see Figure 6.1 ). You can
only manage application files when the AutoBase feature is turned off.
To save an application file, configure all the settings you need through the front panel
and then save the file. When you save the file, the receiver provides a default filename,
which you can change, based on the currently set mode. For example:
Note – If you start an application file that is saved with AutoBase turned on in the file,
then it turns on AutoBase in the receiver, even if it was off before the file was loaded.
Figure 6.1 Application file handling through the front panel of the receiver
If the receiver is set to the following mode: The suggested application filename is:
Base BASE01
Heading HDG01
Moving Base MB01
Rover ROV01
Is AutoBase off?
Follow the usual
AutoBase process.
Active Appfile
<current app filename> *
Do you want to do further
Appfile handling?
Press
L 
to complete
system setup.
Press side arrow.
START
appfile will flash. Scroll
through START, SAVE, DELETE.
Press
L to make decision.
Scroll through application
files in the receiver. Make
decision by pressing
L .
Setup menu.
appears on the System
The following message
Yes No
Display shows the active
application file. Press
L
Note – The '*' after the <current app filename> signifies it is the application file currently in use by the receiver.
to complete.
Yes No