Trimble Outdoors SPSX51 - Manual (Page 165)

SPSx51 Modular GPS Receivers User Guide 163
Upgrading the Receiver Firmware F
The Settings Review window appears. This screen prompts you to connect the
receiver, suggests a connection method, and then lists the receiver configuration
and selected operation.
7. If all is correct, click Finish .
Based on the selections shown above, the Software Upgrade window appears and
shows the status of the operation ( for example,
Establishing communication
with <your receiver>. Please wait .).
8. Click OK .
The Software Upgrade window appears again and states that the operation was
completed successfully.
9. To select another operation, click Menu ; to quit, click Exit .
If you click Exit , the system prompts you to confirm.
10. Click OK .
Forcing the receiver into Monitor mode
If the receiver will not go into Monitor mode to load new firmware, complete the
following steps:
1. Turn off the receiver.
2. Press and hold
F
while turning on the receiver.
3. Continue to hold the
F
button as the display shows the countdown timer.
4. Once the display shows Remote Monitor Active:1 , release the
F
button.
5. The receiver is forced into Monitor mode and you can load the new firmware.