Watlow Electric Integrated Controller User Manual Rev C EZ-ZONE PM - Manual (Page 52)

Wa t l o w E Z - Z O N E ® P M I n t e g r a t e d C o n t r o l l e r • 5 0 • C h a p t e r 8 F a c t o r y P a g e
Dis-
play
Parameter Name
Description
Set-
tings
Range Default Appears If
[CUSt] [```1] [``20]
[FCty] [CUSt] [CUSt]
Custom Menu Custom 1 Custom 20
[`PAr]
[ PAr] Custom Menu
Parameter 1 to 20
Select the parameters that will
appear in the Home Page.
The Parameter 1 value will ap-
pear in the upper display of
the Home Page. It cannot be
changed with the Up and Down
Keys in the Home Page.
The Parameter 2 value will ap-
pear in the lower display in the
Home Page. It can be changed
with the Up and Down Keys, if
the parameter is a writable one.
Scroll through the other Home
Page parameters with the Ad-
vance Key
‰ .
[nonE] None
[`Pro] Process
[StPt] Set Point
[AC;pu] Active Process Value
[AC;SP] Active Set Point
[``op] Open Loop Set Point
[`i;CA] Input Calibration Offset
[`C_F] Display Units
[USr;r] User Restore Set
[`A;Lo] Alarm Low Set Point
[`A;hi] Alarm High Set Point
[`A;hy] Alarm Hysteresis
[`AUt] Autotune
[`C;M] User Control Mode
[`h;Pr] Heat Power
[`C;Pr] Cool Power
[``ti] Time Integral
[``td] Time Derivative
[``db] Dead Band
[`h;Pb] Heat Proportional Band
[`h;hy] Heat Hysteresis
[`C;Pb] Cool Proportional Band
[`C;hy] Cool Hysteresis
[`r;rt] Ramp Rate
[`CU;r] Current Read
[t;tUn] TRU-TUNE+
®
Enable
[idLE] Idle Set Point
[CUSt] Custom Menu
[P;Str] Profile Start
[P;ACr] Profile Action Request
[`gSd] Guaranteed Soak Deviation Value
[`LL;S] Limit Low Set Point
[`Lh;S] Limit High Set Point
[`L;hy] Limit Hysteresis
Active Process
Value (1, Top
Display)
Active Set Point
(2, Bottom
Display)
User Control
Mode (4)
Heat Power (5)
Cool Power (6)
Autotune (7)
Idle Set Point
(8)
Profile Start (9)
Profile Action
(10)
None (11 to 20)
always
[`iid]
[ iid] Custom Menu
Instance
Select which instance of the pa-
rameter will be selected.
1 to 4 the para meter
may apply to more
than one instance.
[`LoC]
[FCty]
Lockout Menu
[LoC;o]
[LoC.o] Lockout Menu
Lock Operations Page
Change the security level of the
Operations Page.
1 to 3 2 always
[LoC;P]
[LoC.P] Lockout Menu
Lock Profiling Page
Change the security level of the
Profiling Page.
1 to 3 3 always
Note: Some values will be rounded off to fit in the four-character display. Full values can be read with another interface.
If there is only one instance of a menu, no submenus will appear.